|
Edward Lowton
Editor |
|
ARTICLE
Recuperative Oxidisers
23 April 2025
Recuperative Oxidisers are targeted at industrial process where there is a combination of energy demand and effluent oxidation. These types of Thermal Oxidisers are mainly suitable for higher VOC concentrations and lower effluent flow rates.
Pollutant gases are heated to high temperature – typically in excess of 800°C – in a combustion chamber for 0.6 – 2.0 seconds to fully oxidise them before being discharged to the atmosphere. Using Heat Recovery units, energy is recovered from the exhaust stream for reuse in the process or elsewhere, thereby reducing total operating costs.
Advantages of Recuperative Oxidisers:
- Continuous control of emissions
- Simplicity of control and management
- Quick start up
- High energy recovery
- Safety and reliability with full hazard audit
- Range of effluent 500 to 30,000 Nm³/h
MORE FROM THIS COMPANY
- Thermal fluid system
- Steam raising system on skid or in container
- Carbon Trust accreditation
- Service & Maintenance
- Keeping the bitumen flowing
- Babcock Wanson UK introduces DCT regenerative oxidisers and solvent recovery systems
- Training course for coil boiler operators
- Regenerative Oxidisers
- Babcock Wanson launches FM Pack Water Tube Boilers
- Babcock Wanson extends Modulo+ range
RELATED ARTICLES
- No related articles listed
OTHER ARTICLES IN THIS SECTION
