Unattended production achieved

Product divert is achieved with a small reversing conveyor located onto a swan neck conveyor in the well of the machine and at any stage in production an operator can energise to reverse and transfer a shot to an integral sample drawer for QC inspection.

Metal detection is based on UPM inserting a search coil under the inclined section of the swan neck in the well of the machine. When a foreign body is detected it will energise an audio-visual alarm and stop the belt conveyor, allowing an operator to check and remove the contamination.

This process does not affect the moulding machine cycle as products continue to be produced and accumulated on the conveyor until the operator has reset to start again.

Product cooling is necessary to avoid deformation to the mouldings which are produced in PP on multi-cavity tools ranging from 8-16 impressions mould and 4 sprues with a section thickness of 5 to 15mm. UPM fitted a cooling tunnel with high flow air fans to reduce the temperature from 80 to 20°C.

For parts separation, the system works via a roller drum with central adjustment for the gap to allow ease of changing so the sprues exit onto another swan neck for transfer to a granulator and mouldings discharge. This then goes to a third swan neck for conveying to the box filling station.

On achieving the correct pre-weight/count the overhead conveyor will stop; the full box is indexed off and an empty box brought onto the weight scale which initiates the overhead conveyor to start again repeating the cycle. When all boxes are full a sensor will energise an audible /visual alarm to alert an operator.

The central control is a PLC controlling all aspects of the system interfacing with the variable speed drives on each conveyor and connecting to the weigh scale.

Rutland expressed total satisfaction with the UPM project team who installed and commissioned the system which is operating trouble-free 24/7.